Betreff: GS750 Plus plotter | Name: Capital Monument (capitalmonumentco@netzero.net) | 15.08.2001 00:39:16
Am unable to plot to Gerber GS750 plus plotter. Tried using HS15/750 driver with no luck. Plotter works with Gerber software. What should I try next?
All past answers:
Hello Alan, did you already try to disable the FiFo Buffers for the COM port at which the plotter is connected to? Is the protocol set to hardware? Best regards Hans Friedrich Holz / Support
I am having a similar problem using FlexiSign. The output dialog window shows "Cutting ... 40%" then "Cutting ... 99%" and just stops. Nothing happens on the GS750. I noticed that there is a bank of DIP switches on the board inside the left cover on the GS750, and all the switches are set in the same direction. How can I determine if these switches are set correctly? This might be whats causing my problem.
Hi, I am looking for information, I would like to go about cutting from CorelDraw. I am currently cutting with a Gerber Gs750 plus but I am wanting to move my programs to a brand new powerhouse computer I have but I am at the point where I need to upgrade CorelDraw anyway and this new computer wont accept the old version of Gerber I have when trying to install. I had a hunch that it was because this is a 64-bit opperating system running on Windows 7 rather that a 32-bit?? running on XP. So I would hate to have to update both CorelDraw and Gerber So I would like to cut out the middle man and cut directly from CorelDraw. Thank you, Josh Sherwood Gem City Memorials